Heating & Air Conditioning in Somers, NY

Tommys Heating and Cooling LLC handles residential and light-commercial heating and cooling across Somers and the surrounding area. From an AC that quit in a heat wave to a furnace that won't light on the first cold night, the fastest way to get help is to call — you'll reach a local technician, not a call center.

Furnace repair

Ignition failures, flame sensors, blower motors, and no-heat emergencies on gas and electric furnaces.

Furnace installation

High-efficiency furnace installs with correct venting, sizing, and thermostat setup.

Emergency service

Urgent no-heat and no-cool calls handled fast, before small faults become failures.

Indoor air quality

Filtration, humidifiers, dehumidifiers, and ventilation for healthier air.

Heat pump service

Install, repair, and tune-ups for air-source and cold-climate heat pumps.

AC repair

Diagnosis and repair of central air systems — warm air, weak airflow, refrigerant leaks, and electrical faults.

Heating & Cooling in Somers, New York

From lake-effect snowbelts upstate to humid city summers, New York weather works systems from both ends — Somers needs heating that survives deep winter and cooling that handles muggy July stretches. Older buildings make ductwork, zoning and right-sizing frequent conversations. Local providers like Tommys Heating and Cooling LLC understand these conditions and service equipment accordingly.

Common HVAC Problems in Somers

Furnace ignition failures

A furnace that clicks but will not light may have a dirty flame sensor, faulty igniter, or gas supply issue — problems best diagnosed by a trained technician.

Frozen evaporator coil

Ice on the indoor coil chokes cooling entirely. Restricted airflow or low refrigerant are the usual causes, and running the unit while frozen risks compressor damage.

Weak airflow from vents

Weak or uneven airflow usually points to a clogged filter, leaky ductwork, or a failing blower motor. Left alone it forces the system to run longer and drives up energy bills.

Short cycling

A system that starts and stops every few minutes wears out components fast. Causes range from an oversized unit to a faulty thermostat or a clogged condensate switch.

Why Choose a Local New York Company

Local technicians know the housing stock — from older homes with aging ductwork to new builds with high-efficiency systems. Understanding the regional climate means recommendations sized for real conditions, not national averages. A provider who works these neighborhoods daily has seen your exact system and failure pattern before.

Seasonal Tips for New York Homes

Seal drafts around doors and windows — reducing heat loss lets the furnace cycle less and last longer.
If pipes run through unheated spaces, keep the system running at reduced temperature during deep freezes even when away.
Install a carbon monoxide detector on every floor if you heat with gas or oil, and check batteries each fall.
Replace the furnace filter before heating season starts — restricted airflow is the top cause of winter no-heat calls.

Frequently Asked Questions

How can I lower my heating and cooling bills?

Regular maintenance, fresh filters, a programmable thermostat, sealed ducts, and sensible temperature setbacks together typically trim 10–25% off energy use without sacrificing comfort.

How long does an air conditioner last?

A well-maintained central air conditioner typically lasts 12–17 years. Systems that run long seasons or skip maintenance wear out sooner, while regular tune-ups and prompt repairs stretch lifespan toward the upper end.

Why is my AC running constantly in summer?

During heat waves some runtime is normal, but nonstop operation with poor cooling suggests low refrigerant, dirty coils, duct leaks, or an undersized system. A service visit can pinpoint which.

What are signs of duct problems?

Rooms that never reach temperature, whistling sounds, dusty air, and high bills all point to leaky or unbalanced ductwork. Sealing and balancing often deliver the biggest comfort improvement per dollar.

What size HVAC system does my home need?

Sizing depends on square footage, insulation, windows, ceiling height, and local climate — not guesswork. An oversized unit short-cycles and an undersized one never keeps up, so a proper load calculation matters.